Equeron Logo

Troubleshooting

Why Am I Losing Pressure Across My Filter?

\

Diagnose excessive pressure loss in industrial water filtration systems.

Pressure loss across a filter means the water is losing energy as it passes through the screen and housing.[1][2] Some pressure drop is normal. Excessive pressure loss is different: it can reduce downstream flow, lower nozzle performance, starve equipment, or cause pumps to operate away from their intended condition.

Possible Causes

  • Debris buildup on the screen
  • Filter is too small for the flow rate
  • Screen micron rating is too fine
  • Cleaning cycle is not fully removing debris
  • Flow rate exceeds the filter's nominal capacity
  • Pressure gauges or taps are blocked, inaccurate, or installed in poor locations

What to Check First

Start with measurement.[3][4] Confirm that the inlet and outlet pressure readings are reliable, taken at comparable locations, and observed at a known flow rate. Then compare clean pressure drop to dirty pressure drop. If pressure loss is high immediately after cleaning, the filter may be undersized, the screen may be blinded, or the system may be flowing more water than expected.

Observation
Pressure drop falls after flushing, then rises again
Likely direction
Normal loading or high debris concentration
Observation
Pressure drop stays high after flushing
Likely direction
Incomplete cleaning, screen blinding, or inadequate flush conditions
Observation
Pressure drop is high even with a clean screen
Likely direction
Filter may be too small, flow may be too high, or screen may be too fine
Observation
Gauge readings do not make sense
Likely direction
Verify gauges, tubing, pressure taps, and installation orientation

If pressure loss remains high after cleaning, inspect the screen, verify flow rate, and confirm that the selected micron rating is appropriate for the application. Persistent pressure loss may require a different filter size or screen configuration.

Pressure loss should also be interpreted in the context of the whole system curve. If a pump, valve position, downstream demand, or operating mode has changed, the filter may appear to be the problem because it is the easiest restriction to measure.[5] Confirm the operating point before assuming the filter itself has changed.

References

  1. U.S. EPA, Process Design Manual for Suspended Solids Removal: https://nepis.epa.gov/Exe/ZyPURL.cgi?Dockey=9101AVYN.TXT
  2. University of Florida IFAS Extension, Screen Filters in Drip Irrigation Systems: https://ask.ifas.ufl.edu/publication/WI009
  3. Oregon State University Extension, Inspecting and Maintaining Irrigation Systems: https://extension.oregonstate.edu/catalog/em-9869-inspecting-maintaining-irrigation-systems
  4. ASHRAE Handbook, Condenser Water Systems: https://handbook.ashrae.org/Handbooks/S20/SI/S20_Ch14/s20_ch14_si.aspx
  5. ASHRAE Handbook, Cooling Towers: https://handbook.ashrae.org/Handbooks/S20/IP/s20_ch40/s20_ch40_ip.aspx

Share this via